Wiper and Washer
Wiper and Washer
Front Windshield Wiper
Turn the top of the left control lever, and the working mode of the windshield wiper is as follows:
- In position ① , the wipers are not operating.
- In position ② , the wipers are intermittent operating.
- In position ③ , the wipers are operating at low speed.
- In position ④ , the wipers are operating at high speed.
Front Windshield Washer
Press the washer button ⑤ on the left control lever to spray washer fluid onto the windshield, and the wipers will operate simultaneously.
After releasing the button, the wipers will continue to wipe three times and automatically wipe once again after a few seconds.
If the washer button ⑤ is pressed briefly, the wipers will only wipe once.
CAUTION
- When the ambient temperature is below 0 ℃ , spraying windshield washer fluid onto the front windshield may cause the fluid to freeze on the glass, blurring the driver's view and compromising driving safety. If it is necessary to clean the front windshield, do so while driving at low speed or when the vehicle is stationary.
- If snow or ice obstructs the front windshield wipers, do not operate the wipers, as doing so may burn out the wiper motor. Remove the snow or ice on and around the wiper arms before turning on the wipers.
- Turn off the wipers when washing the vehicle, cleaning the windshield, or performing maintenance in the front compartment.
- After washing the vehicle in an automatic car wash, if smudges remain on the windshield after wiper operation, these may be caused by wax or other residues. Clean the windshield using windshield washer fluid after the automatic car wash.
- Do not operate the windshield wipers on a dry or dirty windshield. Dry wiping without fluid may damage the wiper blades. Additionally, accumulated dirt on the windshield may scratch the glass; remove the dirt before spraying and wiping.