Precautions

Wearing a seat belt incorrectly will not only fail to bring protection, but may cause other serious injuries.

WARNING
  • All passengers in the car should fasten their seat belts when driving. Child seats should be selected and used correctly for child passengers, and must be installed on both sides of the rear seat.
  • Do not wrap your seat belt when using it. Wrapping the seat belt around the body will increase the pressure of the seat belt on the body and reduce the protective effect of the seat belt.
  • The seat belt should be adjusted as tightly as possible without affecting the comfort, so as to better achieve the protection required by the design. If the seat belt is not fastened tightly, it will greatly reduce the protective effect on the user.
  • Be sure to fasten the upper part of the seat belt tightly over your shoulders and chest, and do not bypass it from behind or under your arms. The seat belt should avoid the face and neck when crossing the shoulder, but should not slide down from the shoulder. If the seat belt is used incorrectly, it may cause serious injury.
  • If the seat belt passes under the arm when wearing it, the passenger may be seriously injured. In case of a crash, the passenger's body may move forward too much, which increases the probability of injury to the passenger's head and neck, and makes most of the seat belt force act on one side of the ribs, resulting in injury.
  • It is strictly forbidden to insert the seat belt bolt substitute into the buckle to eliminate the alarm that the seat belt is not fastened.
  • It is strictly forbidden to make any changes to the seat belt, otherwise it will prevent the seat belt retractor from effectively retracting the loose belt.
WARNING
  • If the fabric of the seat belt is worn or damaged, replace it with a new one.
  • After a vehicle collision, please go to Authorised dealers to inspect all seat belt assemblies, including retractors and locking clips. If necessary, go to Authorised dealers for replacement and installation of the seat belt system components.
Check the Seat Belt

The seat belt retractor will lock the slide of the seat belt when the following three conditions are encountered:

  • When pulling the seat belt out of the retractor quickly;
  • When the vehicle decelerates rapidly;
  • When the seat belt retractor tilts at a large angle.

To check the reliability of the seat belt, grab the upper section of the seat belt and pull it quickly. At this time, the retractor should lock the seat belt. If the seat belt cannot be locked by the coiler, please go to Authorised dealers for inspection or repair.